Reflecto Adhesive Vehicle Markings Set 5921M

Set content: 2 or 4 marking sheets ••• reusable film with microsuction structure ••• various sizes ••• left-handed & right-handed ••• high reflectivity ••• red/white

• Manufacturer: Reflecto
• Set content: 2 or 4 adhesive sheets
• Reflective Film: Orafol^® ORALITE^® 5921M
• Directions: 1 or 2 x left-handed and 1 or 2 x right-handed
• Standards: German DIN 30710, French TPESC-B
• Reflectivity class: RA2/C
• Colour: red/white

Choose your set of adhesive vehicle markings to match your requirements best. The sets include either two or four sheets and can be delivered in various sizes. The reusable markings feature Orafol^® ORALITE^® 5921M reflective film on an adhesive film with microsuction structure and provide excellent adhesion performance and maximum flexibility at the same time.

Please note: Application only to even and smooth surfaces, as otherwise the adhesive effect is not guaranteed.

Features of Reflecto Adhesive Vehicle Markings 5921M

• easy application, repositioning and removal thanks to the adhesive film with microsuction structure
• highly reflective film with excellent performance even in wet conditions
• hard-wearing: resistant to water, weak acids, salts, alkalis, occasional fuel spills
• cold and heat resistant (-30 °C to +60 °C)
• service life of 5 years
• reusable sheets: microsuction side can be cleaned with water if adhesion capacity weakens due to dust or dirt

Application Information

• surfaces must be thoroughly cleaned before applying the sheets
• application ideally in room temperature conditions
• after use reapply to carrier film to avoid material sticking together or getting dirty
• potential residues can be wiped off with a damp cloth
• store in dry place and avoid exposure to direct sunlight

Care instructions for the reflective film

• remove panels before cleaning your vehicle in a car wash or with high pressure
• clean reflective film with lukewarm water and detergent using a sponge or soft brush
• rinse with water and dry
• please do not use any abrasive materials on the film

Note: Due to the manufacturing process, a fine welded joint may occur on the reflective sheet at regular intervals. That is not a production fault but a regular feature of the film.